Acoustic Signals - AEG FSS62800P Benutzerinformation

– = the rinse aid empty
notification is activated.
2. Press to change the setting.
3. Press on/off to confirm the setting.
6.4 The rinse aid level
It is possible to set the released quantity
of rinse aid between level 1 (minimum
quantity) and level 6 (maximum quantity).
Level 0 deactivates the rinse aid
dispenser and no rinse aid is released.
Factory setting: level 4.
How to set the rinse aid level
Make sure the appliance is in user mode.
1. Press .
• The indicators
are off.
• The indicator
flash.
• The display shows the current
setting: e.g.
– The levels of rinse aid range
from 0A to 6A where level 0A
means rinse aid is not used.
2. Press
repeatedly to change the
setting.
3. Press on/off to confirm the setting.

6.5 Acoustic signals

Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
Make sure the appliance is in user mode.
1. Press .
, , and
continues to
= level 4.
• The indicators
are off.
• The indicator
• The display shows the current
setting.
– = the acoustic signal is
deactivated.
– = the acoustic signal is
activated.
2. Press to change the setting.
3. Press on/off to confirm the setting.
6.6 AirDry
AirDry improves the drying results with
less energy consumption.
During the drying phase, the
door opens automatically
and remains ajar.
CAUTION!
Do not try to close the
appliance door within 2
minutes after automatic
opening. This can cause
damage to the appliance.
If, afterwards, the door is
closed for another 3
minutes, the running
programme ends.
AirDry is automatically activated with all
programmes excluding
applicable).
To improve the drying performance refer
to the XtraDry option or activate AirDry.
ENGLISH 11
, , and
still flashes.
(if