General Assembly Instructions - Vacmaster VQ1420SWD Bedienungshandbuch

GENERAL ASSEMBLY INSTRUCTIONS

A Philips head screw driver is required for assembly.
WARNING
: DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE PLUG IS
DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Undo the latches. (fig.2)
3. Lift the power head off the container. (fig.3)
4. Remove the contents from inside the container, make sure you have all contents as listed on
page 6. (fig.4)
5. With the power head removed, turn the container upside down. Insert the feet with casters
into the slots, apply downward pressure and secure them with supplied screw. Do not over-
tighten screws. (fig.5a)
6. Find the rear wheel and foot marked "1" and insert it into the rear slot on base marked "1".
Insert the rear wheel and foot marked "2" into rear slot "2" on base and secure them with the
supplied screws. Do not over-tighten screws. (fig.5b)
7. Insert the handle into the slots located on the top of the power head and secure it with the
screws provided. Do not over tighten the screw. (fig.6)
8. Your vacuum comes ready for dry vacuum cleaning with cartridge filter pre-installed. If
cartridge filter is not installed, refer to page 10 for filter installation. (fig.7 & 8
9. Optional, for improved dust bag, fit dust bag flange onto the inlet stub, taking care not to
damage the bag. (fig.9)
10. For wet vacuum cleaning, install the supplied foam filter. If foam filter is not installed, refer to
page 10 for filter installation (fig.10)
11. Place the power head back on the container, and secure into place using the 2 side latches.
(fig.11 & fig.12)
12. Insert the locking end of the hose into the port of the container and turn to lock in to place.
(fig.13)
13. Choose the desired accessories and extension wands and push onto the suction tube.
(fig.14)
6