Clas Ohlson BT-202 Bedienungsanleitung Seite 6

Saving station presets
1. Switch the radio on and press [
source. "FM" appears on the display.
2. Tune into a station using the instructions above.
3. The radio has 10 station presets. Hold in [
slots "P01–P10" flashes.
4. Press [ ] or [ ] to select a preset slot.
5. Press [ SET/MEM/M+ ] again to save the station on the current preset slot.
Selecting existing presets
Press [ SET/MEM/M+ ] to select the desired preset station.
Connecting an external Bluetooth device
1. Switch the radio on and press [
source. "BT" appears on the display and the Bluetooth indicator (8) flashes quickly.
2. Activate Bluetooth on the device to be paired with the radio.
3. The radio will appear on your device as BT-202, select it and pair it with your device. Refer to
the instruction manual of your device for further clarification if you are unsure.
4. Once pairing has been successful, the radio will beep and the LED will flash slowly.
5. Start playback on your device. Set the desired volume levels both on your device and
the radio. Other playback settings can now be controlled using the controls on the radio or
the external device.
Note:
• If you are prompted to enter a PIN code on your device, you should enter 0000 (four zeroes).
Certain devices may also require you to approve the connection.
• If you have connected a mobile phone to the radio via Bluetooth and receive a call whilst you
are listening to music, the music will be switched off automatically. Once the call has been
ended, music playback will be resumed (if your phone settings enable this).
Changing Bluetooth device
If you wish to change one Bluetooth playback source device for another:
1. Turn off the Bluetooth connection on the first device.
2. Hold in [ SET/MEM/M+ ] until the Bluetooth indicator flashes quickly.
3. Connect the new device as instructed above.
Connecting an external device via the AUX IN socket
1. Switch the radio on and press [
"AUX" appears on the display.
2. Plug an audio cable with a 3.5 mm connector into the AUX-IN socket (12) and connect
the other end to the external device.
3. Start playback on the device.
4. Check and adjust the volume level on the connected device and the radio.
5. Other playback settings should be controlled from the external device.
Note: It is not possible to control playback (change tracks, etc) from the radio when a device is
connected via the AUX-IN socket.
SOURCE ] again to select FM radio as the playback
SET/MEM/M+ ] until one of the station preset
SOURCE ] again to select Bluetooth as the playback
SOURCE ] again to select AUX-IN as the playback source.
6