Kathrein EXR 2908 Bedienungsanleitung Seite 4

Multi-switch
EXR 2908
EXR 2998
Cascadable multi-switch for splitting 8 Sat levels and
terrestrial signals to multiple receivers
Only one downlink per receiver needed (two for twin
receivers)
Facility to select horizontal/vertical, low/high, Sat position A/
position B independently for each receiver using DiSEqC™
controls
If not using DiSEqC™ controls, changing the horizontal/
vertical, low/high of Sat position A can be performed, also by
tone burst changing Sat position A/position B
Integral amplifi er for low attenuation in Sat signal band
Integral pre-emphasis to equalise cable attenuation
Terrestrial signals also receivable with Sat receiver switched
off
Terrestrial band: 5-862 MHz, passive
High degree of insulation between outputs
Can be remote fed via the horizontal low inputs.
All other inputs are voltage-free (enabling operation with
UAS 485)
For indoor mounting
EXR 2908
Multi-switch for 8 connections, with integral power supply unit
Low power consumption based on high-effi ciency short-
circuit-proof switch-mode power supply unit
Can be extended using EXR 2998
EXR 2998
Multi-switch loop-through for system extension with eight
connections each
Highly cascadable (up to 40 connections)
Settings for receivers with DiSEqC™
Setting
DiSEqC™ "On"
22 kHz and tone burst to "Off"
Settings for receivers without DiSEqC™
Setting
22 kHz High/Low
Tone Burst Pos. A/B
*) The terms for the settings in the receiver menus are specifi c to the respective model and manufacturer!
Sat-IF splitting system (8 x Sat-IF)
Multi-switch
20510019
20510020
Effect
All inputs can be selected
Changeover time is shortened
Effect
All inputs position "A" can be selected
All inputs position "A" and "B" can be selected
EXR 2908
20510019
EXR 2998
20510020