Inhaltsverzeichnis
Werbung
8
EUROPORT HPA40
EUROPORT HPA40 Controls
(3)
(2)
(3)
(1)
(4)
(7)
(8)
(6)
(9)
(10)
(11)
9
Quick Start Guide
(EN)
Controls
(1)
LOUDSPEAKER.
(2)
CARRY HANDLE.
(3)
HOLES FOR SHOULDER STRAP.
(4)
The rotary MIC LEVEL control
allows you to adjust the
volume level.
(5)
POWER switch turns the device on
and off . When turned on, the LED of
the POWER switch lights up.
(6)
LOW BAT LED indicates that the
rechargeable battery needs to
be charged.
(7)
CHARGE LED fl ashes yellow as
long as the rechargeable battery
is charging. It goes out when the
battery is fully charged.
(8)
Connect the supplied BEHRINGER
XM1800S microphone to the
MIC IN input.
◊ ◊
Never hold the microphone
directly in front of the
loudspeaker. Feedback hazard!
When operating the device,
keep the microphone behind the
loudspeaker to avoid feedback.
(5)
(12)
(9)
You can connect an external sound
source (CD player, MP3 player, etc.)
to the LINE IN input.
Charging the battery
The HPA40 ships with a rechargeable, internal battery that can power continuous audio playback for up to 8 hours. We recommend that you fully charge the
battery before your fi rst use.
To charge the battery for the fi rst time, follow this procedure:
1.
Turn off the HPA40 by pressing the POWER switch.
2.
Connect the unit to an AC power outlet. The CHARGE LED will light to indicate the battery is charging.
3.
Keep the unit plugged in to AC power until the CHARGE LED indicates the battery has been fully charged.
NOTE: The HPA40 uses a sealed lead-acid gel battery, and the battery will slowly self-discharge when the HPA40 is not in use. Before storing the HPA40 for an
extended period, fully charge the battery before storage, and then charge again every 3 months.
NOTE: The lead-acid battery needs to be recharged every 3 months for continued operation. Please replace the battery if the HPA40 operating time noticeably
decreases, even after a full charge cycle.
(10)
Connect to the power supply via the
The device's SERIAL NUMBER
polarized DC IN connector. A fi tting
is found on the bottom side of
power adapter is supplied. Use the
the unit.
device only with the included
(12)
DIGITAL WIRELESS USB input
power supply.
accepts the optional BEHRINGER
(11)
COMPARTMENT FOR BATTERY
ULM wireless microphone receiver.
AND SHOULDER STRAP.
The LED indicates wireless
To insert the battery, open the
microphone signal input.
compartment's cover. The bottom
half of the compartment is used
for the battery. Open the latch to
access the battery compartment.
Insert the battery as follows:
The terminals must face the device
with the positive terminal (red)
on the side of the HPA40 control
panel (to the left, as seen from
the rear panel). Insert the battery
and close the latch. Close the
battery compartment.
NOTE: The HPA40 ships with a
rechargeable internal battery
that can power continuous
audio playback for up to 8 hours.
We recommend that you fully
charge the battery before your fi rst
use. See the "Charging the battery"
section for more information.
Werbung
Inhaltsverzeichnis
