Charging The Battery; Environmental Information - Flymo EASICUT 500CT Bedienungsanleitung

Battery Care
1. If over a period of time the battery quickly runs down
after a full 5-6 hour charging period, a replacement
battery is needed.
2. There will be some charge present in the battery but
to ensure maximum running time, recharge your
product for 5-6 hours before use.
3. To prevent permanent battery damage, never store in
a discharged condition.
4. Contact your local approved service
centre/dealer/distributor for a replacement battery and
Initial Charging Procedure
1. Use the charger indoors only.
2. Ensure the charger is not exposed to moisture.
3. Plug the charger (B1) into a suitable household
electrical wall socket and switch on.
4. The red indicator lamp (C1) glows continuously
during charging.
5. Full charge will be achieved in 5-6 hours. During
charging the charger becomes warm. This is normal
and means the charger is operating correctly.
• Awareness of the environment must be considered
when disposing of 'end-of-life' product.
• If necessary, contact your local authority for disposal
information.
BATTERY DISPOSAL
• The battery should be taken to an Authorised Service
Centre or your local Recycling Station.
• Do NOT dispose of used battery with household waste.
• Do NOT dispose of battery to water.
• Lead/Acid batteries can be harmful and should be
disposed of through the recognised recycling facility in
accordance with European Regulations.
• Do NOT incinerate.
• Your product is uniquely identified by a silver and black product rating label.
• We strongly recommend that your product is serviced at least every twelve months, more often in a professional application.
If any part is found to be defective due to faulty
manufacture the guarantee period, Husqvarna Outdoor
Products, through its Authorised Service Repairers will
effect the repair or replacement to the customer free of
charge providing:
(a) The fault is reported directly to the Authorised
Repairer.
(b) Proof of purchase is provided.
(c) The fault is not caused by misuse, neglect or faulty
adjustment by the user.
(d) The failure has not occurred through fair wear and
tear.
(e) The machine has not been serviced or repaired,
taken apart or tampered with by any person not
authorised by Husqvarna Outdoor Products.
(f) The machine has not been used for hire.
(g) The machine is owned by the original purchaser.
(h) The machine has not been used commercially.
* This guarantee is additional to, and in no way
diminishes the customers statutory rights.

Charging the Battery

Environmental Information

Service Recomendations
GUARANTEE AND GUARANTEE POLICY
Battery
for safe disposal of your old battery.
5. Battery
18 Volt 1.7 Amp/Hour
Sealed for Life
• IMPORTANT
DISPOSE OF YOUR OLD BATTERIES SAFELY
DO NOT CUT OPEN, BURN OR INCINERATE.
Winter Storage
1. Fully charge for 5-6 hours before winter storage.
2. Avoid extended storage without re-charge.
3. Store in a cool dry place.
Re-Charging Your Product
1. Re-charge the battery as soon as the cutting power
of your product begins to die and slow down.
2. Avoid running the product into "deep" discharge, i.e.
avoid flattening the battery completely.
3. Follow the procedure outlined in the Initial
Charging Procedure.
4. Charging the battery according to these instructions
should ensure maximum battery life.
The symbol
indicates that this product may not be treated as
household waste. Instead it shall be handed over to the
applicable collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
negative consequences for the environment and human
health, which could otherwise be caused by
inappropriate waste handling of this product. For more
detailed information about recycling of this product,
please contact your local council office, your household
waste disposal service or the shop where you
purchased the product.
Failures due to the following are not covered, therefore it
is important that you read the instructions contained in
this Operator's Manual and understand how to operate
and maintain your machine:
Failures not covered by guarantee
* Replacing Cutting Line.
* Failures as a result of not reporting an initial fault.
* Failures as a result of sudden impact.
* Failures as a result of not using the product in
accordance with the instructions and
recommendations contained in this Operator's Manual.
* Machines used for hire are not covered by this
guarantee.
* The following items listed are considered as wearing
parts and their life is dependent on regular
maintenance and are, therefore not normally subject
to a valid warranty claim: Blades.
* Caution!
Husqvarna Outdoor Products does not accept liability
under the warranty for defects caused in whole or part,
directly or indirectly by the fitting of replacement parts
or additional parts that are not either manufactured or
approved by Husqvarna Outdoor Products, or by the
machine having been modified in any way
"High Power"
No maintenance required
on the product or on its packaging
ENGLISH - 2