Filling The Water Tank; Electrical Connection; Dispensing Spout; Starting - FlyTek ZiP Professional Betriebs- Und Wartungsanleitung

Remove the steel lid (ref.G) to refill the water tank. WE RECOMMEND TO USE A WATER-SOFTENER OR A
LIMESCALE SACK that must be periodically replaced. If you do not do so, limescale deposits inside the machine
may alter its correct functioning, as well as the warranty's validity. After the introduction of the softener inside the
water tank, fill the tank with drinkable water, possibly with a low quantity of calcium. You can fill the water tank
through the use of a funnel or a bottle. For all these operations remove only the round lid on the right (the one
with drain pipes) of the tank. The round lid on the left (the one with only one pipe) must not be touched.
The machine is equipped with a sensor that detects the water level in the tank. If the water reaches a too low level,
the ongoing brewing will be suspended and the water-depletion light (ref.P) will start flashing, meaning that you
need to refill the tank as explained above. To avoid this process, we recommend to verify the water level by
watching through the eyelet placed on the right side of the machine.
The power source's potential difference cannot be modified by the user. Before the
connection to the electricity grid, please verify that the potential difference of the grid
corresponds with the one of the machine, as indicated on the data plate.
The dispensing spouts are placed on the upper side of the machines.
During the brewing, do not touch the spouts and do not expose the face to hot parts of the
appliance (risk of burns). The warming surfaces of the machine remain hot after the
usage!
Switch on the machine pressing the main green-lighting switch placed on the left side of the machine; its indicator
light will be lighting. It is now possible to decide which single parts you prefer to switch on: left coffee serving units
and/or right coffee serving units through their own switches (ref.E); steam and hot water dispenser boiler through
its own switch (ref.K); cup warming shelf through its own switch (ref.L). All these components can be switched on
or switched off separately.

FILLING THE WATER TANK

ELECTRICAL CONNECTION

DISPENSING SPOUTS (RIF. B)

STARTING

11