Klarstein Cleanbutler 3G Turbo Anleitung Seite 20

EN
20
Clean up the cyclone system
1. Hold the filter assembly on the lid handle counterclockwise and pull out the filter
assembly after rotation in the end to separate the filter components from the cyclone
cone.
2. Separate filter cotton and HEPA components within the filter assembly. Knock
gently filter cotton, HEPA assembly, cyclone cone on the trash, rough remove dust
adhesion, when necessary, can be directly washed with water, but after washing
must be completely dry before you can re install back to use.
3. Rotate clockwise in the end after aiming the filtering component on the locking
block of the cyclone cone, filter components and cyclone cone are fixed.
4. The locking block on the cyclone dust collection system is aligned and pressed into
a locking block of the dust cup, make the cyclone dust collection system back to the
dust cup.
5. Remove the motor inlet sponge, gently knock, rough remove dust adhesion.
When necessary, can be directly washed with water, but after washing must be
completely dry before you can re-install back to use.
Clean up the electric floor brush
1. Press the electric floor brush release button, remove the electric floor brush.
Arbitrary sliding electric brush to the bottom side of the rolling brush locking block,
remove the rolling brush. Clean it.
2. After the cleanup completed, install the rolling brush inside the electric floor brush.