Bestron ASV45W Gebrauchsanweisung Seite 19

user's instructions
montAGe - preparations for assembling
Unscrew the locking ring (F) from the motor-housing (by turning it anticlockwise) and remove the ring from
the motor housing.
montAGe - Assembling the fan
1. F it the rear of the fan housing (B) onto the motor-
that the openings are aligned precisely with the
lugs on the motor housing and that the grip is at
the top.
2. S lide the locking ring onto the shaft, and screw it
tight (clockwise).
3. S lide the fan blades onto the shaft, making sure
that the notches are aligned precisely with the
two keys on the shaft.
4. F it the spinner onto the shaft and tighten it
(anticlockwise) whilst preventing the fan blades
from moving.
5. T he rim has five clamps (A). Carefully fit the rim
around the rear half of the fan housing, making
sure that the housing falls into the upper clamp of
the rim, so that you can connect the two halfs of
the fan housing with the nut and bolt (C). Use a crosshead screwdriver to screw the bolt into the nut.
6. Close the other clamps.
7. L oosen the stand lock fitted to the rear of the control unit.
8. Fit the fan onto to the upright, and tighten the lock.
operAtion - Ventilate
1. Set the fan on the floor, on a level surface.
2. A djust the stand to the required height, see
Figure 4. Loosen the height lock (by turning it
anticlockwise). Adjust the stand to the required
height and tighten the height lock (by turning it
clockwise).
3. T ilt the fan to the required angle (see Figure
5). You can set the fan:
a. t o blow horizontally (position a) or angled
slightly downwards (position b). Tilt the
ventilator housing and motor housing to
the required angle.
b. t o oscillate from left to right (with a sweep
of 90 °). This will ventilate much of the
room. Press the oscillation button on the
motor housing fully in.
c. r emain in the same position whilst the fan
is turning. This will ventilate one area. Pull
out the oscillation button until you hear it click.
4. Put the plug into the wall socket.
5. Switch on the fan by pressing one of the three speed buttons.
a. Speed 1 the fan operates at low speed.
b. Speed 2 the fan operates at normal speed.
c. Speed 3 the fan operates at high speed.
6. Stop the fan by pressing the stop button (position '0').
A
E
C
19
housing, making sure
F
B
D
C