Herunterladen Inhalt Inhalt Diese Seite drucken

ReefMaster DC100 Bedienungsanleitung Seite 54

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

PIONEERmanREV
11/19/01
6:00 PM
How to set-up the Underwater Housing
Set up camera
1. Insert 4 fully charged Ni-MH batteries (size AA, capacity at least 1600 mAh). See page 53 for more battery
information. Make sure you insert the batteries with the correct + and – polarity.
2. Clean camera lens with dry, clean cotton cloth.
3. Make sure camera focus knob (lens) is set to standard distance. DO NOT SET TO MACRO.
4. Remove camera strap since this may prevent the camera from correctly seating itself inside the housing.
5. Set camera to Sea mode. If you are using an External Flash, set camera to External Flash mode. See page 25
for detailed instructions on how to set camera to Land, Sea or External Flash modes.
Set up housing
Opening and loading of the housing should be done only in dry cool air, such as in an air-conditioned room to
prevent fogging.
1. Open the housing by pulling up latch on side of housing. Do not extend housing lid beyond its stop point or
damage may occur to the hinge area.
2. Carefully inspect O-rings for damage and make sure O-ring is firmly seated in its
3. Clean the housing glass lens port using clean, dry cotton cloth. It is recommended
4. Carefully insert camera into housing. Make sure camera is clean and dry.
5. Insert two Anti-Fog desiccant capsules into special slots inside housing. Note: New
6. Carefully clean O-rings and inside of housing area where O-ring makes contact. Use
Page 45
groove. If O-ring is damaged and requires replacement, contact SeaLife Service
Center (For service details, see page iii).
to apply anti-fog solution to the inside surface of the housing lens.
desiccant capsules will be blue in color. As the desiccant absorbs moist air, it turns
from blue to light pink. Replace desiccant capsules when color changes to light pick.
cleaning brush provided in Care Kit. O-ring must not be wet when sealing housing,
allow these areas to dry.
O-Ring must be absolutely clean of all lint, sand or other small particles.
Do not grease O-rings.
45

Werbung

Kapitel

Inhaltsverzeichnis
loading

Verwandte Produkte für ReefMaster DC100

Diese Anleitung auch für:

Dc200

Inhaltsverzeichnis