Go/on 1330881 Bedienungsanleitung Seite 30

USING Vacuum cleaner
1:Before using the appliance, first pull out a sufficient length of electric cable and plug it into the mains socket. The
yellow mark on the cable is the maximum length that must not be exceeded.
To switch on the appliance press the foot pedal button
2:To rewind the power cable,press the button
with one hand and guide the cable with the other hand to ensure that it does not whip around causing damage.
Caution:
Never operate the vacuum cleaner without the dust bag or the motor filter, otherwise the device could be
damaged.
Changing the dust bag
If the vacuum's suction is reduced, this may be because the bag needs changing. Lift the floor nozzle off the
floor, set the suction force regulation to MAX, switch on the vacuum cleaner using the on/off button, and look at
the bag change indicator. If it is red, the bag must be changed.
1.Turn off and unplug the vacuum cleaner.
2. Remove the hose, open bag cover by pushing
fingers and lifting bag cover.
3. Grasp the cardboard at the top of the dust bag and carefully remove
the bag from the vacuum
4. Put the bag in the bin. Make sure that there are no holes in it
5. Insert a new dust bag into the vacuum cleaner.
The vacuum cleaner must never be used without a dust bag.
6. Close the vacuum cleaner again.
7. Always replace the bag after sucking up large quantities
of fine material, such as fine sand, cement, flour, etc.
the latch up with your
cleaner.
on the casing with your foot.
.
30