Compatibility List; The Kit Includes; Tools Required - XZENT X-F220 Bedienungsanleitung

COMPATIBILITY LIST
Model Model Version
Fiat Ducato III 250/251
Fiat Ducato III 250/251
Fiat Ducato III 250/251
Citroën Jumper II 250/250D/250L
Peugeot Boxer II 250/251
CAUTION
- The installation of the XZENT system should be carried out by an authorized installer. Specific knowledge and tools are required to do the installation. Incorrect
installation can cause damage to the vehicle and the XZENT system.
- Correct functioning can only be guaranteed when you use the XZENT original accessories included in the kit or optionally available. The XZENT system and the
original accessories must under no circumstance be modified or altered in any way. Inappropriate actions can cause damage to the vehicle and the XZENT system.
NOTE
- The target vehicle must factory configured with preinstallation for a radio system. The XZENT system is not compatible with vehicles that are equipped with an
OE radio or OE navigation system from the factory.
- This device installation manual applies to vehicle platforms appearing in the above compatibility list, and in a condition as offered by the respective vehicle
manufacturer. Other differing configurations and installations of motorhome manufacturers are not considered in this installation manual. If you have questions or
vehicle-specific problems please contact the relevant motorhome manufacturer.
- The XZENT system is equipped with an integrated DAB+ receiver. To make use of this you will need a suitable DAB antenna (not included in kit) that must be
connected to the XZENT system.
- In order to obtain better radio reception, it is recommended to equip the vehicle with an active antenna system (FM / DAB).
- If the target vehicle is equipped with a resistor based multifunction steering wheel, no additional accessories are needed to support the steering wheel remote
control functions.
- Software updates to the XZENT system are installed with a USB memory device. Therefore when fitting the system make sure that the USB connection of the
XZENT system will still be accessible later (installation of USB extension cable).
- If you have questions or problems relating to the XZENT system, please contact the dealer from whom you purchased it.
THE KIT INCLUDES
No. Article
1 XZENT- system
2 two-piece mounting frame
3 Phillips screws
4 Remote control
5 GPS antenna
6 Antenna adapter ISO/DIN
TOOLS REQUIRED
- Torx screwdriver T25
- File
- Phillips screwdriver
- Release tool made of plastic
- Insulating tape
- Hand saw or equivalent tool
4
FIAT DUCATO III
Model Year
2006 - 2011
2011 - 2014
ab 2014
ab 2006
ab 2006
Qty
1
2
4
1
1
1
No. Article
7 Main connection cable
8 USB extension cable
9 20-pin connection cable (4.2, Cam)
10 Connection cable SWC-adapter
11 Connection cable parking brake
12 Double-sided adhesive pad
Qty
1
1
1
1
1
1