Instruction Manual (Gb) - Compac A28-HC G1 Bedienungsanleitung

Instruction Manual
Air-hydraulic jack, A28-HC G1, A3216-C, A4020-C G1,
A5816-C G1, A5830-C G1
Important: Read and understand this manual before use!
WARNINGS - SAFE USAGE INSTRUCTIONS:

This jack is only a lifting device.

Do not move or dolly the load while on the jack.

The load must be supported immediately by other appropriate means.

Do not overload. Overloading can cause damage to or failure of the jack.

Lift only on areas as specified by the vehicle manufacturer.

Do not use more than the 3 standard extensions in sequence.

This jack is designed for use only on hard level surfaces capable of sustaining the load. Use on other than
hard level surfaces can result in jack instability, damage and possible loss of load.

It is recommended that wheels on vehicles must be aligned.

The vehicle must NOT be braked when lifting. This is to ensure a straight / vertical lift, and to prevent the
load to move, and thereby damage the jack.

No person should be located in, on, or under a load that is being jacked or is supported only by a jack.

The factory set and sealed safety valve settings must not be changed.

Maximum permissible pressure: 12 bar (170 PSI).

Disregarding these warnings may cause the load to fall down, damaging the jack, and result in personal
injury, property damage or even death.

The jack must be inspected regularly, at least once a year by a qualified person.
Preparation of the jack:
Please note that it is necessary to use a little oil for lubrication during assembly of the jack. During transport
this oil may drip to the bottom of the carton. This is inevitable and not a sign of defect. Unpack the jack and
inspect for any damage. Oil the mechanical parts before starting up - and regularly thereafter.
! IMPORTANT: When the jack has been turned over or upside-down, a little oil will come into the hoses and
come out with the pump exhaust. This is not a sign of defect and will stop after operating the jack for some
time. Wipe away any excess oil.
Connect the air hose. (min. 8 bar – max.12 bar). Maximum lifting capacity is achieved at 10-12 bar.
! IMPORTANT: The air supply MUST be fitted with oil lubrication and water separator.
Use of the jack:
Adjustable handle:
The handle can be placed in three different positions by pulling the lever and moving the handle.
Lifting a load:
The operating valve on the top of the handle should be turned slowly to the right,
the pump is activated and the jack lifts.
Lowering the load:
The operating valve on the top of the handle should be turned slowly to the left,
and the jack lowers.
After use always return the lifting cylinder to its lowest position to protect the cylinder.
IMPORTANT: Always place the handle in the horizontal position before lowering.
There is a risk that the handle/chassis will be damaged, if a vehicle is lowered onto the
handle, while the handle is not in the horizontal position.
Instruction Manual A model (DK) V.1 / Compac 2014 / lvm
1