Loading Default Values - Wachendorff UR3274 Betriebshandbuch

shows
Load
loads the new data and starts again.
When writing the parameters, the led turns red and on
completing the procedure it changes to green. It is possible
to repeat the procedure without any particular attention.
Updating programming module
To update the programming module values, follow the
procedure described in the first method, setting display 2 to
so as not to load the parameters on controller
----
Enter configuration level and change at least one parameter.
Exit configuration. Changes are saved automatically.
7.9

Loading default values

This procedure allows to restore factory settings of the
instrument.
Press
1
for 3 sec.
1 If on activation the controller does not display
have been saved on the programming module, but it is possible to
update values.
, then confirm using the
• With the controller not connected
to power supply.
The
equipped with an internal battery
with an autonomy of about 1000
uses.
Insert the programming module
and press the programming button .
Effect
Display 1 shows
with the 1st digit
flashing, while display
2 shows
pass
key. The controller
programming
0000
memo
UR3274U - User manual
module
.
1
Do
it means no data
is
85