Operating Instruction - Blumfeldt 10032818 Bedienungsanleitung

WARNING:
ALWAYS ACCESS THE CONTROLS AND CYLINDER VALVE FROM THE SIDE OR THE
REAR OF THE HEATER.
DO NOT ATTEMPT TO RE-LIGHT UNTIL 5 MINUTES HAVE ELAPSED.
Light the heater
Open the valve on the gas cylinder.
The control knob should be aligned with the "
knob for around 20 seconds (this will allow gas to flow from the pilot and the burner). While
still holding down the control knob fully, immediately push the impulse ignition button to
light the atmosphere analyser (ODS).
Hold the knob depressed for about 20 seconds until the atmosphere analyzer remains lit
after releasing the knob.
If flame goes out, release the knob and Impulse Ignition button, wait 30 seconds and repeat
the procedure.
To get low heating power, press the knob slightly and turn it to the (Low) position.
Ignition/High
Shut off the heater
• Turn the control knob to the " " position
• To switch off the equipment, close the valve on the gas cylinder.
• Do not move the heater when it is operating.

Operating Instruction

" position. Push down fully on the control
Low
16