Operation; On/Off; Table; Miter Gauge - Holzmann TSM 250 Betriebsanleitung

11.3

Operation

11.3.1 ON/OFF

To turn the machine on, press "I" (green).
To turn the machine off, press "O" (red).

11.3.2 Table

To tilt the worktable loosen the quick release,
bring work table to desired position and tighten
quick release again.
To set exactly 90 ° use a protractor.

11.3.1 Miter gauge

The miter gauge is provided for use on the
grinding table.
The miter gauge can be used for angles of up
to 45°, to the left or right, by releasing the
locking button and adjusting the miter gauge
to the desired angle. The button is then
tightened again.

11.3.1 Dust collector plug

There is a dust collector plug with a diameter
Ø35 mm.
Always use a suitable dust collector (eg
vacuum cleaner)!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
OPERATION
22
TSM 250