Chargers - POP Avdel ProSet PB2500 Bedienungsanleitung

PB3400 (fig. 4 & 5)
•
Select the correct jaw pusher or jaw pusher assembly (R) and Tail Guide (V) that matches the Nose Piece
selected. Reference the Accessories Manual for appropriate nose equipment.
NOTE: The Tail Guide that comes installed on the tool as purchased matches the installed Nose Piece. Reference
the Accessories Manual for appropriate nose equipment for the actual Tail Guide part number.
•
Put the Tail guide (V) into the Spindle of the in Gear housing (AD). Put spindle clutch spring (AB) and
spindle clutch (AA) over the tail guide (V) and tighten Puling head assembly (AC) counter clockwise using
a 24mm spanner.
•
Insert jaw pusher (R) into jaw pusher spring (S)
•
Reassemble jaw set (Q) and jaw guide (P) onto Pulling head (T)
NOTE: Do NOT use spanners to mount jaw guide (P) onto front clutch (U). Manual tightening of Jaw guide (P) is
enough to lock onto front clutch (U)

4.2. CHARGERS

Your tool uses a DEWALT®/POP® Avdel® charger. Be sure to read all safety instructions before using your
charger. The charger requires no adjustment and is designed to be as easy as possible to operate.
Charging Procedure (fig. 2)
•
Plug the charger into an appropriate outlet before inserting the battery pack. (Refer to the Charger
Specifications in Section 2)
•
Insert the battery pack (K) into the charger, making sure the pack is fully seated in the charger. The red
(charging) light will blink continuously indicating that the charging-process has started.
•
The completion of charge will be indicated by the red light remaining ON continuously. The pack is fully
charged and may be used at this time or left in the charger.
NOTE: To ensure maximum performance and life of Li-Ion battery packs, charge the battery pack fully before
first use.
Charging Process
Refer to the table below for the state of charge of the battery pack.
Charge indication
charging
fully charged
hot/cold pack delay
x
problem pack or charger
problem power line
This charger will not charge a faulty battery pack. The charger will indicate faulty battery by refusing to light or
by displaying problem pack or charger blink pattern.
NOTE: This could also mean a problem with a charger.
If the charger indicates a problem, take the charger and battery pack to be tested at an authorised service
centre.
–– –– –– ––
–––––––––––––––––
–– • –– • –– • –– •
• • • • • • • • • • • •
•• •• •• •• •• ••
E N G L I S H
14