Tool Use & Set Up; Operating Instructions; Nose Equipment - POP Avdel ProSet PB2500 Bedienungsanleitung

E N G L I S H
3. Tool Use & Set up
The PB Series of tools are designed for installation of STANLEY Engineered Fastening Blind Fasteners.
DO NOT use under wet conditions or in presence of fl ammable liquids or gases.
READ ALL SAFETY WARNINGS AND INSTRUCTIONS BEFORE PUTTING TOOL INTO SERVICE.
Electrical Safety
The electric motor has been designed for one voltage only. Always check that the battery pack voltage
corresponds to the voltage on the rating plate. Also make sure that the voltage of your charger corresponds to
that of your mains.
Your DEWALT® charger is double insulated in accordance with EN60335; therefore no earth wire is
required.
Using an Extension Cable
An extension cord should not be used unless absolutely necessary. Use an approved extension cable
suitable for the power input of your charger (see Technical Data). The minimum conductor size is 1 mm2; the
maximum length is 30 m.
When using a cable reel, always unwind the cable completely.
Before Use
•
Select relevant size nose equipment and install
•
Ensure that the battery is fully charged
•
Insert Battery Pack into the tool
•
Quickly pull and release the trigger to set the tool to the home position.

4. Operating Instructions

Always wear approved hearing and eye protections at all times when using installation
equipment.
WARNING: Before adjusting tool, always remove the battery pack.

4.1. NOSE EQUIPMENT

ProSet® PB2500 drawing can be found inside the front cover
ProSet® PB3400 drawing can be found inside the back cover
Mounting the nosepiece (fi g. 7).
•
Select the correct nosepiece for the rivet to be installed. Reference the Accessories Manual for appropriate
nose equipment.
•
Tighten the nosepiece (A) into the nose housing (B) by turning it clockwise using 11 mm spanner.
Mounting the jaw pusher and tail guide
PB2500 (fi g. 4 & 5)
•
Select the correct jaw pusher or jaw pusher assembly (R) that matches the Nose Piece selected. Reference
the Accessories Manual for appropriate nose equipment.
•
Insert jaw pusher (R) into jaw pusher spring (S).
•
Reassemble jaw set (Q) and jaw guide (P) onto front clutch (U)
NOTE: Do NOT use spanners to mount jaw guide (P) onto front clutch (U). Manual tightening of Jaw guide (P) is
enough to lock onto front clutch (U)
13