Touratech AVENTURO Mod Gebrauchsanweisung Seite 37

C. THE HELMET
3. The anti-fog lens should now be
positioned in the face shield with its
lower edge parallel to the lower edge
of the face shield. If you need to
change the positioning of the anti-fog
lens, use the balls of your thumbs to
gently bend the face shield apart
until the inner visor can be adjusted
as required.
4. Check all around the anti-fog lens
to make sure that it fits tightly and
evenly against the face shield. Only
if this is the case will the anti-misting
properties function properly.
5. If you have not done so already,
remove the protective film from the
anti-fog lens.
If the anti-fog lens is not air-tight and the face shield mists up, either the
visor is not correctly in place or the pressure on the seal is inadequate.
You can regulate the pressure on the seal by adjusting the eccentric
locking-pins.
Removal
1. Before starting to remove the anti-
fog lens, first lay the face shield on a
soft, clean cloth so that its top edge
is facing you.
72
2. To reduce the pretensioning of the
anti-fog lens slightly if necessary,
use the balls of your thumbs to
carefully bend the face shield
sufficiently apart while applying
pressure with your thumbs to release
the anti-fog lens and move it approx.
2–3 mm forward.
3. Now grip the back of the anti-fog
lens with your index and middle
fingers and lift it off the face shield.
In this position you can easily
remove the anti-fog lens from the
locking pin with your thumb.
4. You can now remove the anti-fog
lens from the face shield.
Note:
To avoid scratching the face schield, never remove or fit the anti-
fog lens unless the visor unit is clean and dry.
When fitting the anti-fog lens, check that neither dust nor moisture
are able to get between the two surfaces.
When removing or fitting the anti-fog lens, it is always best to lay
the face schield unit on a clean, dry cloth.
Note:
In view of the strong air pressure acting when travelling with an
open face shield, we recommend riding with a closed face schield
at all times to prevent any dirt or moisture from getting inside the
helmet.
Note:
Never press the locking pins out with your fingers as they may
break.
EN
73