Fitting Check List - Revelo Buggypod Gebrauchsanleitung

BuggyPod Final Jan 08 1/1/08 22:20 Page 3
WARNING: Avoid serious injury by falling or sliding out.
Always use the safety harness.
WARNING: Placing bags, parcels and/or accessories on the Buggypod®
may cause the unit to become unstable.
WARNING: Follow the manufacturer's instructions.
Read these instructions carefully before use and keep them for future reference.
Your child's safety may be affected if you do not follow these instructions.
WARNING: Put on the brakes of the host pushchair whenever parked.
WARNING: Do not leave children unattended.
It may be dangerous to leave your child unattended.
WARNING: Do not carry extra children or bags on this carriage.
WARNING: Make sure children are clear of any moving parts if you adjust this
carriage otherwise they may be injured.
WARNING: Ensure that all locking devices are engaged before use.
WARNING: Always use the crotch strap in combination with the waist belt.
WARNING: This product is not suitable for running or skating.
WARNING: This seat unit is not suitable for children under 6 months

Fitting Check List

UK/US
PLEASE READ BEFORE CONTINUING
• The Buggypod® can be attached to most buggies and pushchairs including twin pushchairs
and 3-wheelers. The mounting bracket strap can be tightened easily around most buggy and
pushchair frames. The frames can be oval, square, round, thick or thin.
• Looking at the pushchair from the rear or the front, the bars to which you intend to attach
the brackets must be vertical; otherwise the Buggypod®
will not sit vertically.
• The mounting brackets should be attached to two major frame bars on the right hand side
of your pushchair (when viewed from the pushing position) between 35cm-43cm from the
floor and 16cm-37.5cm apart.
For correct installation, the mounting brackets (Part e - see
Components on page 1) need to be positioned to allow the
connector bar (c) to run parallel to the centreline of the host
pushchair. If this is not possible, (e.g. with some 3 wheeler
pushchairs), the connector bar adaptor (d) can be used to
ensure the connector bar is able to run parallel to the
centreline. Please see page 6 for instructions on how to
install the Buggypod® when using the connector bar adaptor.
• You should check that, once fitted, the mounting brackets do not prevent you from
using the pushchair brakes or folding the pushchair.
For more information visit www.buggypod.com