Pouring Coffee; Timer Function - Silvercrest SKA 1000 A1 Bedienungsanleitung

NOTE
► Thanks to the anti-drip function of this appliance, you can remove the vacu-
um flask
put the vacuum flask
2) Once the coffee has run through the appliance completely and no more
coffee is dripping into the vacuum flask
The red control lamp BRÜHVORGANG
displayed.
NOTE
► You can use the AN/AUS button
process.
Pouring coffee
WARNING – RISK OF INJURY!
► Following the brewing process, a small amount of hot coffee may have
collected on the lid
with an absorbent tissue before removing the vacuum flask
appliance.
1) Remove the vacuum flask
2) The lid
3) To pour coffee, turn the lid
at the
4) Before placing the vacuum flask
back until the arrow points at the

Timer function

You can set a scheduled time within a 24-hour period for the appliance to start
brewing coffee.
NOTE
► If you wish to use the timer function, ensure that the correct time has been
set (see chapter "Setting the time").
1) Fill the appliance with ground coffee and water as described previously.
2) Press the AUTO/PROGRAMM button
PROG.
3) Repeatedly press the STD
time (see chapter "Setting the time").
■ 26
│ GB
and pour coffee even during the brewing process. Make sure to
back into the device within 30 seconds, however.
of the vacuum flask
from the appliance.
is shut tight, the arrow on the handle points at the
a half turn until the arrow on the handle points
symbol. You can now pour coffee without the lid
and MIN
, you will hear 6 acoustic signals.
goes out and BREW is no longer
at any time to stop the brewing
. Carefully wipe the coffee
back in the appliance, turn the lid
symbol again.
twice. The display
buttons to set the desired starting
from the
symbol.
falling off.
will read
SKA 1000 A1