Electrolux WOGL9060CN Gebrauchsanleitung Seite 5

4. CONTROLS
A B C
Button Function
Turns the suction motor on and off.
A
Decreases the working speed.
B
Increases the working speed.
C
Activates Intensive speed from any other speed,
D
with the exception of Delay and 24H. This speed
is set to operate for 10 minutes, after which the
system returns to the speed that was set before.
Suitable to deal with maximum levels of cooking
fumes.
Pressing and holding the button for approxi-
mately 5 seconds, with all functions turned off
(Motor+Light), Enables / Disables the Activated
Charcoal Filter alarm.
Starts the Motor in Air Change mode, at a speed
E
that allows suction 10 minutes for hour, after
which the Motor will stop.
Activates automatic switch-off with a 30' delay.
F
Suitable to complete elimination of residual
odours. Can only be activated with the mo-
tor turned on at a Speed other than 24H and
Intensive.
Press and hold the button for approximately 5
seconds to Enable / Disable the Remote control.
Performs a Reset of the Filter saturation alarm
G
when the Button is pressed for approximately 3
seconds.
Decreases the intensity of the Lighting each time
H
the Button is pressed, in cycle.
Turns the lighting system on and off at maximum
I
intensity.
Increases the intensity of the Lighting each time
L
the Button is pressed, in cycle.
Keyboard Lock: it is possible to lock the keyboard, for example when cleaning the
Glass surface, when the Hood has Motor and Lights turned off.Press A for ap-
proximately 5 Seconds to enable or disable the Keyboard Lock, which is always
confirmed by a Beep and an animation on the display motor bar.
E
D
F G
Display
-
The number of lighted segments decreases.
The number of lighted segments increases.
The indicator I flashes and all the segments on the
Display are lit.It is disabled by pressing the Button.
2 Flashes of symbol C – Alarm Enabled.
1 Flash of symbol C – Alarm Disabled.
Displays 24 and the segments on the Display all
light up and then turn off one at a time in cycle.It is
disabled by pressing the Button.
Displays a flashing Clock symbol.It is disabled by
pressing the Button.
2 Flashes of the Horizontal Bars – Remote Control
Enabled.
1 Flash of the Horizontal Bars – Remote Control
Disabled.
After 100 hours in operation the Drop symbol is
displayed to indicate saturation of the Metal Grease
Filters.
After 200 hours in operation the letter C is displayed
to indicate saturation of the Activated Charcoal
filters.
ENGLISH
5
L
I
H