Stand Assembly; Mixing Hints - Belle Group MINIMIX 130 Bedienungsanleitung

GB
1
DO NOT tip mixer onto drum mouth when motor is running
3
CAUTION whilst rotating mixer up into stand position, beware of the drum
kicking back.
5
NOTE: When ready for dismantling the mixer after use, follow all the previous
procedures but in reverse order.
GB
A few hints on mixing. First add water, about 1
should go in after some of the aggregates work consistently to the ratio of ingredients as listed below for whatever
type of concrete mix you are working to. Beware of low grade aggregates, this only leads to trouble later on with
sinking and frost spoiling the appearance of the pour. Also importantly do not get the concrete mix too wet as this
can reduce the strength and is less able to withstand weathering. Never throw material into the mixer, trickle it
steadily over the rim or it will stick firmly to the back of the drum and can only be dislodged by stopping the mixer.
The approximate mixing time for concrete is 2
has entered the drum. Over mixing can reduce strength and cause segregation of the coarser aggregates.
Keep your mixer clean, the slightest trace of material left in the drum, will harden and attract more each time you
use it until the machine is useless. Do not throw bricks into a mixer drum to clean it out. The best method is 1"
gravel and clean water, use plenty of it, as this will do the job in half the time.
Minimix 130 OPERATORS MANUAL

STAND ASSEMBLY

MIXING HINTS

1 / gallons approximately, depending on the type of mix. Cement
2
1 / minutes, this is taken when all the material, including the water
2
8
2
4
6