Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• FIRST USE OF YOUR ICE MAKER
During transportation, the incline angle of the cabinet should not be over 45°. Do not turn
o
the ice maker upside down. Problems could occur in the compressor and sealed system.
Remove all packing material and please check carefully that your ice maker is in good
o
condition. There must not be any breakages on the unit and/or damages to the cord/plug.
The ice maker should be placed horizontally on a level surface. To ensure the proper
o
ventilation for your ice maker keep a distance of 150mm from other objects at the top, back
and each side. Please do not install the ice maker near an oven, radiator, or other heat
source.
Before using the ice maker for the first time, please wait 2 hours after positioning it, and
o
keep the front lid open for at least 2hours.
You must confirm that the voltage indicated on the ice maker corresponds with the voltage
o
in your home.
Pure water may not be used with this unit, spring water is recommended.
o
• OPERATING INSTRUCTIONS
STEP 1.
Open the lid and fill the water reservoir with water.
o
Note: Make sure the water level is not over the ice collecting tray.
o
STEP 2.
Connect to the power.
o
STEP 3.
Select desired ice cube size by pressing 'SELECT'
o
Note: Please select the (S) when ambient temperature is below 15°C. When the ambient
o
temperature is higher than 30°C, large ice cube sizes are recommended.
STEP 4
Press 'START' button to turn unit on. The ice maker begins to work.
o
Note: For the first three cycles, the ice may be small and irregular in size.
o
STEP 5
If the 'ADD WATER' icon is red and you hear the tone 'DI', then take out the basket and add
o
water - same as in step 1.
Note: If no water is pumped up to the water tray over two cycles but there is sufficient
o
water in the water tank, then please open the drain cap, and let some of the water run out.
STEP 6
If the 'ICE FULL' icon is red and you hear the tone 'DI DI', please take out the ice with the
o
scoop.
Note: When the ice collecting tray is full please remove the ice immediately, Do not allow
o
the ice collecting tray to overfill.
You must press 'STOP' then the 'START' button to restart the ice maker after you add water
o
or take out some of the ice.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
28
Werbung
