Inhaltsverzeichnis
Werbung
6
A
To Replace Mower Blade Drive Belt
MOWER DRIVE BELT REMOVAL
•
Park tractor on a level surface. En gage parking brake.
•
Lower attachment lift lever to its lowest position.
•
Remove mandrel cover (A).
•
Remove any dirt or grass clippings which may have
accumulated around mandrels and entire upper deck
surface.
•
Remove spring (B) from eyebolt (C).
•
Remove belt (D) from all pulleys (E).
•
Remove the belt from around the electric clutch (F) on
the engine shaft.
MOWER DRIVE BELT INSTALLATION
NOTE: For ease in installing the deck belt, refer to the routing
decal on the cutting deck.
BELT ROUTING
E
C
B
F
D
E
•
Place the belt around all pulleys.
•
Double check belt routing to make sure it matches the
routing decal, and that the belt does not have any twist.
Correct if needed.
•
Connect spring to eyebolt.
•
Adjust belt tension until spring is extended to a length of
5.75" (14,6 cm).
-
Loosen inner adjustment nut (G).
-
Turn outer adjustment nut (H) clockwise ( ) to increase
tension, counterclockwise ( ) to decrease tension.
-
Tighten inner adjustment nut securely.
H
•
Replace mandrel cover (A) and secure with fasteners.
84
F
D
E
G
C
B
Werbung
Inhaltsverzeichnis
