Herunterladen Inhalt Inhalt Diese Seite drucken

Handling The Remote Controller; Replacing Batteries - Mandik KFR-09GW/BP Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Handling the remote controller

Location of the remote controller.
Use the remote controller within a distance of 8 meters fromthe appliance, pointing it
towards the receiver Reception is confirmed by a beep
The air conditioner will not operate if curtains, doors or other materials block the signals
from the remote controller to the indoor unit
Prevent any liquid from falling into the remote controller Do not expose the remote
controller to direct sunlight or heat
If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air
conditioner may not function properly Use curtains to prevent the sunlight from falling
on the receiver
If other electrical appliances react to the remote controller, either move these applianc-
es or consult your local dealer
Do not drop the remote controller Handle with care
Do not place heavy objects on the remote controller, or step on it
Using the remote controller holder (optional)
The remote controller can be attached to a wall or pillar by using a remote controller
holder (not supplied, purchased separately)
Before installing the remote controller, check that the air conditioner receives the sig-
nals properly
Install the remote controller with two screws
For installing or removing the remote controller, move it up or down in the holder

Replacing batteries

The following cases signify exhausted batteries Replace old batteries with new ones
Receiving beep is not emitted when a signal is transmitted
Indicator fades away
The remote controller is powered by two dry batteries (R03/LR03 × 2) housed in the back
rear part and protected by a cover
1 Remove the cover in the rear part of the remote controller
2 Remove the old batteries and insert the new batteries, placing the (+) and (-) ends cor-
rectly
3 Install the cover back on
NOTE: When the batteries are removed, the remote controller erases all programming. After
inserting new batteries, the remote controller must be reprogrammed.
Do not mix old and new batteries or batteries of different types
Do not leave the batteries in the remote controller if they are not going to be used for
2 or 3 months
Do not dispose batteries as unsorted municipal waste Collection of such waste sepa-
rately for special treatment is necessary
CAUTION
CAUTION
27
EN

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Kfr-12gw/bp

Inhaltsverzeichnis