4Operati on
4 Operation
Connection to Hose:
1. A supply of dry and clean conpressed air according to EN ISO 7494-2 must be
provided.
2. Screw the Coupling Device onto the dental unit's tubing and finger tighten onto the
threaded sleeve of the handpiece tube.
3. Then tighten fully with key supplied.
4. Lightly spray the O-rings with maintenance spray.
5. The coupling remains permanently screwed to the hose.
Changing the handpieces:
1. Press and rotate the handpiece onto the Coupling Device and push until it clicks
audibly into place.
2. Check to be sure the handpiece is properly connected.
Page 22
MEISINGER Condura EN