Herunterladen Inhalt Inhalt Diese Seite drucken

Warm Audio WA-47 Bedienungsanleitung Seite 6

Kondensatormikrofon
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

FEATURES
1. Contents
Your WA-47 package includes; the WA-47 microphone, power supply, IEC power cable, shockmount,
7 pin Gotham Audio cable, and wood storage box.
2. Power Switch
The power switch is located on the power supply.
3. IEC Power Inlet
The IEC power inlet is located on the rear side of the power supply and allows for a standard IEC cable
to connect the power supply to your wall power outlet.
4. 115v/230v Voltage Selector Switch
A voltage selector switch is located near the IEC inlet on the power supply and allows for the user to
set the appropriate voltage for the country they are located. We advise to be careful with this switch
because plugging in the unit at the wrong voltage setting will likely damage the WA-47 and its power
supply. Plugging in the WA-47 power supply at the incorrect voltage could even cause injury or death.
Typically the voltage selector switch will be pre-set to the proper voltage of the country where the prod-
uct was purchased and should not be changed.
5. Polar Pattern Select Switch
The polar-pattern selection switch is located on the power supply and provides 9 different pattern op-
tions. Patterns are: Cardioid, Omni, Figure-of-eight and 6 additional "in-between" patterns.
6. 7 pin microphone cable connector (female)
A 7 pin female microphone cable connector is located on the power supply. The 7 pin Gotham brand-
ed cable included in the WA-47 box is connected to this connector on one end and to the WA-47
microphone on the other.
7. XLR Output
A standard 3 pin XLR male connector is located on the power supply. The microphone's signal will
exit this connector. Connect this connector to a preamp via a standard 3 pin XLR microphone cable.
2
5
4
3
6
7
5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis