Position And Fixing - NAYATI NGETL 5-50 Handbuch

9. If the appliance has not preset to the gas availability, you must convert it into another gas type.
Authorized personnel must do this by referring to the technical data (primary air regulation and
nozzle table), changing the main burner and pilot burner nozzles. Once this has been done, a
new rating data plate should be affixed to the new data by referring to the new gas type.
NEVER USE FREE FLAME TO FIND GAS LEAKS!

• Position and Fixing

Authorized personnel must do the installation. Install the appliance according to National
Safety Standard about gas-heated standard. Place the appliance in good ventilated room with
permanent ventilation ducts to guarantee sufficient exchange of air and keep the work place
healthy. If the Gas Economic Table Low not connected to a flue, it is recommended to install it
under efficient hood, which could evacuate burned gases and cooking steams. Make sure that
any object around or under Gas Economic Table Low does not obstruct air volume required for
combustion. Put away any flammable materials near Gas Economic Table Low. When the
appliance is freestanding, keep a distance at least 20 cm from side, and 10 cm from rear walls.
Especially when the appliance close to wall and does not protected with fire-resistant materials
made. Install the appliance separately or side by side with other appliance according to
recommended range. Put Gas Economic Table Low on solid, flat, and horizontal floor. Adjust
the height of the four feet by using brackets. Before turn the appliance ON, remove the
protective film. Remove any adhesive with appropriate solvent. Eliminate all packaging
material according to national laws.
ORIENTAL
Manual Instructions for Gas Economic Table Low
Warning !
14