Instructions For Disposal - Magnat CINEMOTION 510 Bedienungsanleitung

•
MAINS CABLE: The mains cable must always be suitable for operation and it should only ever be laid
out in a manner that prevents it from being trodden on. It should not be pinched by objects either,
as this can damage the cable. When using plugs and power strips it must be ensured that the cable
is not kinked at the point where it emerges from the socket. Do not connect or remove the mains
cable with damp hands.
• The mains plug is used as the disconnecting device. Disconnecting devices shall remain readily
operable.
•
OVERLOAD: Sockets, power strips and extension cables should not be overloaded. If an overload
occurs, there is a risk of electric shock and fire.
•
SETTING UP: Please read the installation instructions.
•
The device should only be positioned or mounted on a solid surface and not on moving base frames,
otherwise there is a risk of injury.
•
Only use attachments/accessories specified by the manufacturer.
DAMAGE THAT MUST BE RECTIFIED BY A SPECIALIST:
If any of the following damage occurs, disconnect the device from the mains immediately and contact
a specialist to conduct the repair work:
•
The device should not continue to be operated if there is visible damage to the mains cable. A
damaged cable should not be repaired, but must be replaced.
•
Damage to the mains socket at the device.
•
If moisture or water has entered the device or foreign objects have fallen into the device.
•
If the device has fallen and the housing is damaged.
•
If the device does not work properly, even though all of the information in the instruction manual
has been observed.
Only those subsequent alterations approved by the manufacturer may be conducted.
Only original spare parts should be used for repair.
After conducting any repairs the safety of device should be checked to ensure it is functioning correctly
and safely.
Repairs must always be conducted by qualified specialists, as you might otherwise be exposed to
dangerous high voltage levels or other hazards.

INSTRUCTIONS FOR DISPOSAL

In accordance with European Directive 2012/19/EU all electrical and electronic appliances must be
disposed of separately via local collection points. Please observe the local regulations and do not
dispose of your old appliances with normal household waste.
GENERAL NOTES ON CONNECTING YOUR MAGNAT SATELLITE SPEAKERS
The connectors are located at the rear of the satellite speakers. They are equipped with a clamping
mechanism for cables cross-sections of up to 1 mm². To connect the satellites, please use normally
available 2 x 0.75 mm² – 2 x 1 mm² loudspeaker cables. The cables are to be cut to the required length,
the ends stripped and the end of the wires twisted to make it easier to connect them to the terminals.
Always turn off the amplifier or receiver before connecting or disconnecting loudspeaker cables. For good
sound the cables must be connected so that the speakers are "in phase". This means that the black
negative terminals on the speakers (-) must be connected to the negative (-) terminals on the amplifier,
the positive (+) speaker terminals to the positive (+) amplifier terminals.
Before switching on the system double-check all your connections and make sure that the terminal
screws are tight and that there are no short circuits caused by stray wire filaments – this could cause
serious damage to your amplifier!
10