Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
ATTENTION!
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE SETTING UP OR
USING THE TRAVEL COT.
KEEP THE MANUAL
FOR FUTURE REFERENCES. READ THE MANUAL
CAREFULLY TO AVOID INJURIES.
1) All assembly fittings should always be tightened properly and that fittings should
be checked regularly and retightened as necessary.
2) Never leave your child unattended, always keep an eye on your child.
3) After unfolding, make sure that the travel cot is secure and that all sides are
audibly engaged or locked.
4) Do not dismantle the playpen when the baby is in the playpen.
5) Do not allow your baby to climb out of the travel cot.
6) Do not use the travel cot without the supplied mattress.
7) Do not leave anything in the travel cot, which could cause suffocation or
strangulation.
8) Do not leave anything in the cot or place the cot close to another product, which
could provide a foothold.
9) Do not use the cot if any part is broken, torn or missing and use only spare parts
approved by the manufacturer.
10) The travel cot, including side rails and buttom pad, should be fully erected before
use. Top rails must be completly locked.
11) Please be aware of the danger of open fire and other strong heat sources - such
as electric stoves, gas stoves, etc. near the playpen.
12) Avoid overloading the travel cot - load capacity up to 18kg.
13) The travel cot is intended for use by only one child and with a weighs less than
15 kg.
14) If opening or closing is not easy, check the travel cot carefully and follow the
instructions to avoid damage.
CLEANING & MAINTENANCE:
1) Use only household soap or detergent with warm water.
2) Use lukewarm water for washing and let it drain and dry thoroughly. DO NOT
BLEACH.
3) Do not store or use the travel cot in places subject to high or low temperature or
humidity, and always ensure adequate ventilation.
MADE IN CHINA
Fillikid GesmbH | Tiefentalweg 1, A-5303 Thalgau, Austria | fillikid.at
ASSEMBLY:
1
1) Take the travel cot out of the
transport bag.
3
3) Unfold both opposite sides, by pulling them
up until you can hear them click into position.
STOWING AWAY:
2
1
1) Take out the mattress
2) Loosen the fixations of the sides by pressing the button in the middle and
and pull the strap in the
drop the sides down to create a "V". If one side does not collapse comple-
middle all the way up, until it
tely, use the strap to pull the center of the floor up to the top further and
is above the frame.
release the middle buttons again. Slide all 4 corners and feet together to
form a small square.
3
4
MADE IN CHINA
2
2) Open the mattress and lay it to the side.
4
4) Press the floor down, until it's completely flat and
stable. Place the mattress in the playpen.
3) Wrap the playpen in the mattress and close the
velcro clasps.
4) Place the travel cot in the transport bag.
Fillikid GesmbH | Tiefentalweg 1, A-5303 Thalgau, Austria | fillikid.at
EN
Werbung
