Connecting The Charger To A Battery Pack Inserted In A Drivepack - FAZUA Focus Originalbetriebsanleitung

Operation
Warning! Monitor the mains voltage. The voltage supplied to the
Charger (1) must be in the range defined in the specifications. The
permissible values are indicated on the charger.
Warning! Read carefully and observe the battery instructions.
Warning! Pay attention to your battery before each use and before
charging. Make sure terminals and surfaces are clean.
Warning! Before using or charging your Battery Pack, always look
for signs of damage like cracks or burns. Never use or charge a
damaged Battery. Please contact your FAZUA Service Partner or
visit the Fazua Service Platform (www.fazua.com/service).
Connecting the Charger to the mains
Connect the power plug (4) of the power cord (3) to the power socket (2)
of the Charger (1). Then connect the mains cable (country-specific) to the
mains supply.
Note! Charge the Battery Pack (7) only when all safety instructions
are followed. Otherwise, stop and make sure all the safety
instructions are followed before starting the charge.
Connecting the Charger to a standalone
Battery Pack
Connect the charge connector (5) of the Charger (1) into the charge
plug (9) of your Battery Pack (7) (Action A).
Connecting the Charger to a Battery Pack
inserted in a Drivepack
The Battery Pack (7) can be charged either standalone or when inserted in
the Drivepack (11) (See Drivepack Instructions).
Connect the charge connector (5) of the Charger (1) into the charge plug (9)
of your Battery Pack (7) inserted in the Drivepack (11) (Action B).
EN
47