Troubleshooting - Cleanmaxx HL-3202 Gebrauchsanleitung

EN

Troubleshooting

If the device does not work properly, check whether you are able to rectify the problem
yourself. If the problem cannot be solved with the steps that are listed, contact the cus-
tomer service department.
Do not attempt to repair an electrical device yourself!
Problem
The device works slowly
or does not work at all.
Low suction force.
The control lamp does not
light up when the device
is connected to the mains
power.
Streaks are left when
cleaning windows or
smooth surfaces.
Unusual odour
22
Possible cause
The battery is empty.
The collecting contai-
ner (5) is full.
The suction opening or
nozzle is blocked.
The adapter is not inser-
ted in the plug socket
correctly or the barrel
connector is not inserted
in the connecting socket
on the device correctly.
The plug socket is defec-
tive.
Check the fuse in the
electrical distributor (fuse
box).
The scraper lip is dirty.
The cleaning agent has
the wrong dosage.
The device is new.
Solution
Charge the battery (see
the "Charging Up the Bat-
tery" chapter).
Empty the collecting con-
tainer (see the "Cleaning
and Storage" chapter –
"Emptying and Cleaning
the Collecting Container").
Switch off the device and
remove the blockage.
Correct the fi t.
Try another plug socket.
Reduce the number of
devices in the circuit.
Clean the nozzle with
scraper lip (see the
"Cleaning and Storage"
chapter).
Correct the dosage.
A new odour is normal
when the device is used
for the fi rst time; it disap-
pears after a while.