Cleaning And Storage; Emptying And Cleaning The Collecting Container; Storage - Cleanmaxx HL-3202 Gebrauchsanleitung

7. Detach the dirt using the wiping cloth. Note: If necessary, rinse out the wiping cloth
under running water!
8. Suck the cleaning liquid up from the surface using the device.

Cleaning and Storage

PLEASE NOTE!
■ Switch off the device before you clean it and make sure that it is not connected to
the mains power.
■ Accessories that are cleaned with water must be completely dry when they are in-
serted back into the device!
■ Do not use any sharp or abrasive cleaning agents or cleaning pads. These could
damage the surfaces.
• The collecting container (5) must be emptied at the latest when it is full, and after
each use (see the "Emptying and Cleaning the Collecting Container" section).
• Clean the housing if necessary using a damp, soft cloth. Dry them with a soft cloth.
• Wash the wiping cloth after every use in accordance with the washing instructions.
• Check the mains adapter (7) and its mains cable for damage at regular intervals.
• Keep the device ready for operation. Charge up the battery after each use (see the
"Charging Up the Battery" chapter).

Emptying and Cleaning the Collecting Container

1. Switch off the device.
2. Open the collecting container (5) carefully by pulling out the seal plug.
3. Pour the cleaning water which has been sucked up into a drain.
4. Rinse out the collecting container by sucking up clear water using the suction
function (see the "Use" chapter) and then pouring it out again. Repeat this process
several times if the collecting container is very dirty.
5. Let all parts dry completely in the air before you put them away.
6. Seal the collecting container again using the seal plug.

Storage

• For practical storage, you can use the mounting bracket (2) to hang the device on a
hook or similar fastening.
• Store the device and all accessories in a cool, dry place which is protected from
direct sunlight and is out of the reach of children and animals.
21 EN