Run Mode - Nowsonic AUTARK LED MASTER II Bedienungsanleitung

Nowsonic Autark LED Master II
GB
User manual
Controls and indicators on the top panel
The Autark Master
LED II
tors on the top panel:
1. and faders
R, G, B W/D
You can manually set any color mixture for the selected channel mode
7 R, G, B W/D
( ) via the and
channel is 0 to 255, the channel assignment is set via the button (
below.
provides the following controls and indica-
faders: the control range for each color
NOTE: In the M1 channel mode (
effect.
2. MIX fader
MIX
Via the fader you can choose between the internal color mixtures
of the Master : the color mixtures are printed on the top panel
LED II
next to the fader.
3. fader
MAC
Via the MAC fader, you can choose between the 8 internal programs
of the LED Master II : Depending on the selected
program is controlled either automatically or dynamically via the
AUTO 8
music. In mode (
the corresponding SPEED
4. SPEED fader
If you have selected the AUTO
you can control the speed of the internal
the SPEED fader. The range is 0.1 to 30 seconds.
5. / Sound Sensitivity fader
STROBE SPEED
STROBE
When you engage the
button ( 10 ), you can set the speed/frequency of the Strobe effect via
STROBE SPEED
the fader from 1 to 20Hz: As long as the
6 ) mode is inactive, the fader controls the music sensitivity (when this
feature was activated by pressing the
8
www.nowsonic.com
), the W/D
R GB
RUN
) you can set the speed for the programs via
fader (4).
mode via the

RUN MODE

LED Master II
mode by pressing the corresponding
RUN MODE
mode).
fader has no
8
mode ( ), the
button ( 8 ),
programs via
STROBE