Nowsonic AUTARK LED MASTER II Bedienungsanleitung Seite 10

Nowsonic Autark LED Master II
GB
User manual
NOTE: A suitable
XLR
to and 3, while ground is soldered to
PIN 2
sure that the wiring doesn't change within the cables: a polarity
error or short circuit between the Pins will at least impair or com-
pletely stop the control functionality.
3) Connect the other (female) plug of the cable to the
socket of the first slave unit.
4)
Connect additional slave units according to this pattern (
output to input).
DMX
Next, you must enter an individual
For further information on this topic, read the documentation supplied
with the unit.
Operation
When the peripherals are connected to the
the control features. Proceed as follows:
1)
Choose a channel mode using the
The following modes are available (for a mode description see
page 6):
R GB
d d
R GBD
d d
audio cable connects the two signal leads
. Please make
PIN 1
DMX
address for each slave unit.
DMX
Master , you can set
LED II
CHANNEL MODE
R GB W
d d
R GB WD
d d
DR GB
d d
DR GB W
d d
The selected mode is shown via the
In
2)
Using the address buttons beneath the fader choose the channel
DMX group which you want to control: you can choose from a total
of 40 channels. The
the current selection. You can choose between the following
channel groups:
For channel 1 to 10, press button
d d
For channel 11 to 20, press button
d d
For channel 21 to 30, press button
d d
For channel 31 to 40, press button
d d
7
button ( ).
10
www.nowsonic.com
s above the button.
LED
of the active group lights to show
LED
1
2
3
4