Sabre 1340GR Betriebsanleitung Seite 105

ENG 50
PROBLEM
14. Unusual vibrations
while working
15. With the engine
running, the machine
does not move when
the drive pedal is
➤
pressed. ( for
hydrostatic drive
models)
If problems continue after having carried out these operations, contact your
Dealer.
WARNING!
!
have the necessary equipment and the technical knowledge.
The guarantee is automatically revoked and the manufacturer declines
all responsibility for any repairs which are badly done.
LIKELY CAUSE
– forward speed too high compared to
height of grass (☛ 5.4.5)
– collector channel is blocked
– cutting deck full of grass
– the blades are imbalanced
– blades loose
– fixing bolts loose
– disengage lever in positon «B»
(☛ 4.33)
Do not take on complicated repair work if you don't
TROUBLESHOOTING
SOLUTION
– reduce forward speed and/or raise the
cutting deck
– wait for the grass to dry
– remove the grass-catcher and empty
the collector channel (☛ 5.4.7)
– clean the cutting deck(☛ 5.4.10)
– balance or replace the damaged bla-
des (☛ 6.3.1)
– check that the blades are firmly fitted
(☛ 6.3.1) (remember the left-hand
thread of the right hand blade)
– check and tighten all the fixing bolts of
the engine and frame
– put into position «A»