Filling The Water Tank; Set Iron Temperature; Spray Function - HOYER Handel DB 1750 C3 Bedienungsanleitung

6.1 Filling the water tank

DANGER!
Pull the mains plug 8 out of the socket
before you fill up the water tank 10.
• Use clean tap water without any addi-
tives (e.g. vinegar, limescale remover,
starch, perfume, softener).
• The integrated anti-limescale protection
reduces limescale deposits for average
water hardness, and thus extends the
service life of the device. If your tap wa-
ter is hard, use distilled water. Where
the water is moderately hard, mix dis-
tilled water and tap water at a ratio of
1:1.
1. Disconnect the mains plug 8 from the
wall socket.
2. Set the steam control 3 to
3. Open the lid 2 (of the water tank) and
tilt the iron forwards slightly to fill it.
4. Use the measuring beaker 16 to pour in
water up to the mark 14 MAX, but at
least up to one quarter. Hold the steam
iron upright to check.
5. Close the lid 2 (of the water tank).
6. Place the steam iron on the base unit 9.
8
GB

6.2 Set iron temperature

1. Figure B: Set the desired temperature
using the temperature controller 13:
- MIN the device is not getting hot
÷
-
÷÷
-
÷÷÷
-
- MAX maximum temperature
2. The temperature control lamp 11 is lit
for as long as the steam iron is heating.
It goes out when the set temperature has
been reached. You can then begin iron-
ing.
.

6.3 Spray function

Use the spray function in order to dampen
dry items of laundry. This option is available
irrespective of the set temperature. For this
purpose, the water tank 10 must be at least
one quarter full.
• Repeatedly press the spray button 4
While doing so, hold the steam iron
horizontally with the tip over the item of
laundry. Ensure that no water sprays
onto the ground.
temperature: up to
approx. 110 °C
(synthetic materials - e.g. poly-
ester)
temperature: up to
approx. 150 °C
(Silk, wool)
temperature: up to
approx. 210 °C
(linen, cotton)
.