Inhaltsverzeichnis
Werbung
Hardware Installation
1. Ensure your computer system is powered down, and the power cable has been
disconnected from the Power Supply.
2. Open your computer case (refer to the computer user manual for details), and place
the 2.5/3.5in SATA HDD Backplane into an available 5.25" slot, lining up the side
installation holes on the HSB2535SATBK (pictured below), with installation holes on
the 5.25" slot inside the computer.
3. Hold the HSB2535SATBK into place, and fix 4 of the included screws through
the installation holes on the 5.25" slot, into the side installation holes on the
HSB2535SATBK.
4. Connect one of the included "18in SATA cables" from an available SATA host port on
your motherboard to the "2.5" Drive SATA port" on the back of the HSB2535SATBK.
5. Connect one of the included "18in SATA cables" from an available SATA host port on
your motherboard to the "3.5" Drive SATA port" on the back of the HSB2535SATBK.
6. Connect a Molex LP4 Power header from your power supply to the "LP4 Power
Connector" on the back of the HSB2535SATBK. If you do not have an LP4 connector
available, use the included "Molex LP4 to SATA Power Adapter Cable" with an
available SATA Power Header from your power supply.
Instruction Manual
3
Werbung
Inhaltsverzeichnis
