Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
IMPORTANT
Use of controls or adjustments or performance of procedures other than those specified herein may
result in hazardous radiation exposure.
CD player Function:
1. POWER BUTTON
Press the power switch to turn the unit on. To switch the POWER off press the POWER switch
again.
2. EJCET BUTTON
Press to load or eject disk. Each press will open or close the disk tray.
NOTE: Disc holder will not open unless stop or pause button has been pushed first.
3. PLAY/PAUSE BUTTON
Each time you press the PLAY/PAUSE button, the operation changes from play to pause or from
pause to play.
4. CUE BUTTON
Pressing the CUE button during play provides a return to the position at which play was started.
5. CD/USB BUTTON
Press this button to choose CD or USB mode while USB connect and the CDs in the tray.
6. TIME BUTTON
Used this button to choose the time mode : Elapsed time, remaining time or total remaining time.
7. REPEAT BUTTON
Use this button to repeat one track or all the track of the CD.
8. RELOOP BUTTON
This button is used to start the last saved loop. To finish the loop, press the reloop button.
9. IN BUTTON
This button sets the beginning of the loop. The Loop indicator on the display flashes.
10. OUT BUTTON
When you press this button, you set the end point of the seamless loop and you start the loop. To
finish the loop, press again this button.
11. CONT. / SINGLE BUTTON
Press this button to switch between the SINGLE and CONTINUOUS play mode. The selected
mode is indicated on the LCD. In SINGLE mode, after each track, the unit stops the reading. In
CONTINUOUS mode, the unit reads all tracks and stops.
12. PROG AND FOLDER CONVERSION BUTTON
In STOP mode, you can program several tracks (20 tracks max):
© Copyright Lotronic 2010
5
Werbung
Inhaltsverzeichnis
