Remote Control Configuration - Peavey Architectural Acoustics PZS 140RA Bedienungsanleitung

C o n f i g u r a t i o n

Remote Control Configuration

The PZS ™ 140RA includes limited support for the D-Series remote
control network. Although the network is supported, only the D-Series
D4S is operable for the PZS 140RA. The D4S is a four-button, flush-
mount panel that can be configured to provide remote access to the
PZS 140RA's matrix/assign functionality. Using the D4S provides a
simple way to provide a remote location access to input or zone
selection.
The D-Series network uses a system of Base Addresses to identify
control function on the network. You can connect up to 32 D4S panels
on a single PZS 140RA, but only eight Base Addresses are supported.
This means that you could have many duplicate panels operating in
"parallel" up to the 32 panel, eight Base Address limit. For more
information on the D-Series system, please refer to the D-Series User
Manual.
When a D4S panel is configured for input channel operation, the
buttons allow for zone selection. Conversely, when the D4S is
configured for zone operation, the buttons provide input channel
selection.
Although the D-Series network includes 32 Base Address options, only
eight are supported on the PZS 140RA. Assigning a D4S to one of these
eight Base Addresses will configure the panel as follows:
P A G E 1 8 P Z S ™ -140RA User Manual
When using the D4S with the PZS
140RA, the buttons always operate
as switches, and thus are not
mutually exclusive. This allows full
matrix assignment, just like the
front panel of the PZS 140RA.
Refer to the D-Series User Manual.