Koala Kare KB200 Bedienungsanleitung Seite 4

KB200
Step 2. Prepare Mounting Surface
Use screws and bolts or other hardware
appropriate to the type of the wall and have it
mounted by a licensed professional.
For Standard Installation
Remove the bed and chassis from the box
and select the wall area where the unit will
be installed. Make sure you have taken into
consideration the operating clearance of 24.1
cm on both sides of the exposed chassis and
58.9 cm from wall surface when open. Measure
from the floor 107 cm on stud center and mark
the wall. The mounting holes are designed for
406 mm stud centers. Ensure the locations
you have marked for the mounting holes are
level before drilling. Drill pilot holes for keyhole
mounting using a 3 mm regular drill bit.
For Masonry or Tile over Stud Wall
Use a 6 mm masonry drill bit for the pilot hole
until you hit the stud. Change bit to 3 mm regular
drill bit.
For Metal Stud or Concrete Block
If the wall has wood studs that are not on 40.6
cm centers, has metal studs or an underlying
surface of concrete block, drill with a 13 mm
masonry bit. (You may have to purchase toggles
before installing.) You must allow a minimum of
inside wall space for toggles to turn depending
on toggles used. Insert and tighten toggles.
Installation Instructions
3
40,6 cm
Frame is equipped
with keyhole slots
to assist with
mounting.
Top two screws at 107
cm (42¼") to meet
ADA Height
Requirements