Conditions Of Use; Conformity To Standards And Directives - bürkert ELEMENT Bedienungsanleitung

TEchNicAL spEcificATioNs
Mechanical specifications
Component Material
Display module PC / PBT

conditions of use

Ambient temperature: -10 to +60°C
Air humidity: < 85%, non condensated
conformity to standards and
directives
The accessory conforms to the CE directives through
the following standards:
EMC: EN 61000-6-2, EN 61000-6-3
English
8
unscrewing the cover on the
measuring device
NOTE
The tightness of the measuring device is not guar-
anteed when the cover is removed.
• Take any precautions necessary to prevent the projection
of fluids inside the box.
The measuring device may be damaged if a metal
component comes into contact with the electronics.
• Take any precautions necessary to prevent contact of
the electronics with a metal component (a screwdriver,
for example).
English
10
→
To u nscre w the
cover, use your
hand or a tool which
can be used as a
lever, taking care
not to scratch the
glass
AssEMbLy
safety instructions
DANGER
Risk of injury due to electrical discharge.
• Before starting work, switch off the power supply and
secure it to prevent restarting.
• Observe all applicable accident protection and safety
guidelines for electrical equipment.
WARNiNG
Risk of injury due to non-conforming assembly.
• The accessory must only be assembled by qualified and
skilled staff with the appropriate tools.
Risk of injury due to unintentional switch on of power
supply or uncontrolled restarting of the installation.
• Take appropriate measures to avoid unintentional activa-
tion of the installation.
• Guarantee a set or controlled restarting of the process
subsequent to the assembly of the accessory.
fitting the display module
20°
English
9 9
→
Turn the cover until
fully unscrewed
→
Unscrew the cover
on the measuring
device as shown
in the previous
paragraph.
→
Set the display
m o d u l e a t a n
angle of ca. 20°
in relation to the
desired position.
English
11 11