Crimping Inserts For Non-Isolated, Exposed Plug-In Connectors (Fig. 9+10); Cleaning, Maintenance And Repair - NovoPress PowerCrimp Betriebsanleitung

PowerCrimp
8.3.2 Crimping inserts for non-isolated, exposed plug-in connectors
EN
(Fig. 9+10)
1. Check whether the nominal width of the connector corresponds to the nominal width of the
crimping insert.
2. Position the connector in the crimping insert and contact locator in line with the cross section.
3. Insert the stripped cable into the connector.
4. Press the start button and hold it down until the crimping operation is completed.
5. After the end of the crimping operation, remove the connector from the crimping device.
8.3.3 Crimping inserts for twisted contacts (Fig. 11+12)
1. Check whether the nominal width of the connector corresponds to the nominal width of the
crimping insert.
2. If necessary, remove the contact locator and turn it by ± 120° into the required position. (Fig. 11)
3. Position the connector in the crimping insert and contact locator in line with the cross section.
4. Insert the stripped cable into the connector.
5. Press the start button and hold it down until the crimping operation is completed.
6. After the end of the crimping operation, remove the connector from the crimping device.
9

Cleaning, maintenance and repair

CAUTION!
Risk of injury during cleaning or repair work from inadvertently pressing the On
switch.
Therefore:
– Comply with the safety instructions and always remove the battery before performing
cleaning, maintenance or repair work.
CAUTION!
Health hazard during cleaning or carrying out maintenance due to the cleaning
and anti-corrosion agents used.
Therefore:
– Observe the safety instructions for the cleaning and anti-corrosion agents used before
performing cleaning or maintenance work.
Service addresses
You can find the addresses of authorised specialist workshops by contacting Novopress or at
www.novopress.de.
Service intervals
Service and repair work may only be carried out by Novopress or the authorised NOVOPRESS specialist
workshops.
Cycles until the service interval
To check the amount of cycles remaining until the required service interval has been reached, turn the
crimping device off and proceed as follows.
1. Switch off the crimping device if it is on.
Press the reset button (8) and hold it down until all LEDs go out.
Release the reset button.
2. Press the reset button (8) and hold it down.
3. Now also press the start button (7) and hold it down.
4. As soon as the LEDs (4) and (5) flash simultaneously, release both buttons.
Service display mode is active.
5. Please refer to the table below for the remaining cycles (actuations) until a service is required.
6. To exit service display mode, press the reset button (8) or the start button (7).
18