CO/Tech 51097X23 Bedienungsanleitung

Remote Controlled
Wall Socket
Art.no 36-6365 Model
Please read the entire instruction manual before using the product
and then save it for future reference. We reserve the right for any
errors in text or images and any necessary changes made to
technical data. In the event of technical problems or other queries,
please contact our Customer Services.
Things to consider:
• Other wireless equipment using the same frequency band can
reduce the transmission range.
• The range of all wireless equipment depends on the type of
obstacles located between the transmitter and the receiver
(e.g. a concrete wall will interfere with the signal more than
a plasterboard wall).
If you experience problems, try the following:
• Turn off any other existing wireless equipment to check
whether this is the cause of the problem.
• Reposition the wireless equipment, shorten the distance
between the transmitter and the receiver or reduce
the number of obstacles (walls, furniture, etc.) between them.
Installation
Note: If you are at all unsure how to install the product, contact
a competent person or qualified electrician.
1. Make sure that the wires that you are connecting the wall
socket to are not energised. De-energise the circuit by
removing the fuse or opening the circuit breaker.
2. Unscrew the old wall
socket from the wall box
and disconnect the wires.
3. Remove the wall plate.
GREAT BRITAIN • CUSTOMER SERVICE tel. 020 8247 9300 e-mail customerservice@clasohlson.co.uk internet www.clasohlson.co.uk postal 10 – 13 Market Place, Kingston Upon Thames, Surrey, KT1 1JZ
4. Connect the wires to the corresponding terminals on
the wall socket:
- L = Line (live/phase)
- N = Neutral
- = Protective earth
5. Attach the wall socket to the wall box.
51097X23
6. Refit the wall plate.
7. Turn the power on.
Operating instructions
Pairing the wall socket with a remote control
1. Hold in the pairing button for 3 seconds. The LED indicator
will flash.
2. Press [ ON ] for the channel on the remote control that you
wish to pair the wall socket with. Hold the button in until
the LED indicator on the wall socket stops flashing.
3. Switch the wall socket on and off using the ON/OFF buttons
on the remote control or with the pairing button.
Deleting the wall socket from a remote control
1. Hold in the pairing button for 3 seconds. The LED indicator
will flash.
2. Press [ OFF ] for the channel on the remote control that you
wish to unpair the wall socket from. The LED indicator on
the wall socket will stop flashing.
3. It is still possible to switch the wall socket on and off using
the pairing button.
Deleting all information from the wall socket
If more than one device paired with the wall socket, they can all be
deleted at the same time.
1. Hold in the pairing button for 6 seconds. The LED indicator
will flash.
2. Release the button.
3. All information will now be deleted.
Troubleshooting guide
The wall • Is the wall socket paired with the remote control
socket as instructed above? Try pairing them again.
does • Check that the device (e.g. light) which is connected
not work. to the wall socket is switched on and not faulty.
• Is the wall socket too far from the remote control?
• Is the signal being blocked by furniture or
furnishings?
Responsible disposal
This symbol indicates that this product should not
be disposed of with general household waste.
This applies throughout the entire EU. In order to
prevent any harm to the environment or health
hazards caused by incorrect waste disposal,
the product must be handed in for recycling so that
the material can be disposed of in a responsible
manner. When recycling your product, take it to
your local collection facility or contact the place
of purchase. They will ensure that the product is
disposed of in an environmentally sound manner.
Specifications
Mains voltage 230 V AC, 50 Hz
433.92 MHz
Frequency
Range 25 m