CO/Tech 51058GBx30 Bedienungsanleitung

Switch Receiver
Art.no 18-1253 Model 51058GBx30
36-3624 51058x36
Please read the entire instruction manual before using the product and
then save it for future reference. We reserve the right for any errors in
text or images and any necessary changes made to technical data.
In the event of technical problems or other queries, please contact our
Customer Services.
Safety
• Make sure that the electrical socket that the product is plugged
into is easily accessible in case it and the connected product need
to be quickly disconnected from the mains electricity.
• Do not connect products of this type to each other.
• Do not cover the product.
Operating instructions
Installation
1. Plug the receiver into
an electrical outlet.
2. Hold in the button on the front
of the receiver for at least 3
seconds and then release it.
UNITED KINGDOM • CUSTOMER SERVICE tel 020 8247 9300 e-mail customerservice@clasohlson.co.uk internet www.clasohlson.co.uk postal 10 – 13 Market Place, Kingston upon Thames, Surrey, KT1 1JZ
3. The LED inside the button
will start to flash slowly.
The receiver is now ready to
be paired with a transmitter.
4. Pair the receiver to the transmitter by following the instructions
accompanying the transmitter. Up to 6 transmitters can be paired
with the receiver.
5. Plug a light into the receiver
and check that the light is
switched on.
6. The light can now
be controlled using
the transmitter.
Note: The light can also be switched on/off manually by pressing
the button on the receiver.
Unpairing all paired transmitters
1. Hold in the button on
the front of the receiver for 6
seconds until the LED inside
the button starts to flash
quickly.
2. When the LED stops flashing,
all the transmitters which
were paired with it will have
been unpaired.
Unpairing one paired transmitter
1. Hold in the button on the front of the receiver which you want to
unpair the transmitter from for 3 seconds and then release it.
2. The LED inside the button will start to flash slowly. The receiver is
now ready to unpair from the transmitter.
3. Press in the [ OFF ] button on the transmitter (make sure to choose
the correct [ OFF ] button if the transmitter can connect to multiple
receivers). The transmitter will now unpair from the receiver.
Care and maintenance
• The receiver should be unplugged from the wall socket if it is not to
be used for a long time.
• The receiver should be cleaned by wiping it with a dry cloth.
Troubleshooting guide
The receiver is • Has the receiver been paired with
not working, a transmitter as described above? Try pairing
the LED is not lit. them again.
• Check that the light is properly plugged into
the receiver and that it is switched on and
not faulty.
• Try plugging the light into another electrical
outlet to make sure that it works.
• Is there electricity in the outlet the receiver is
plugged into?
Responsible disposal
This symbol indicates that this product should not be
disposed of with general household waste. This applies
throughout the entire EU. In order to prevent any
harm to the environment or health hazards caused by
incorrect waste disposal, the product must be handed
in for recycling so that the material can be disposed
of in a responsible manner. When recycling your
product, take it to your local collection facility or contact
the place of purchase. They will ensure that the product
is disposed of in an environmentally sound manner.
Specifications
Mains power supply 220–240 V AC, 50 Hz (18-1253)
230 V AC, 50 Hz (36-3624)
Frequency 433.92 MHz
Max range 25 m
Load (resistive bulb) 0−3680 W
Load (inductive) 0−613 W