auna DBT-2 Anschluss- Und Anwendungshinweise Seite 9

Pairing
You can connect 2 BT devices (like smartphones, tablets or computers) with the DBT-2.
• Press MFB (B) for at least 7 seconds until the red and blue LEDs flash alternately.
• Activate BT on your BT device and connect it with „DBT-2".
• After the connection was successfully established, press and hold MFB again until the LED stops glowing.
• Turn the Headphone back on.
• Activate BT on your second BT device and connect it with „DBT-2" as well.
• Meanwhile you can turn on BT on your 1st mobile phone. Click previous pairing record and connect.
Functions
Listen to muslc or make a call.
• Multi functions button (MFB):
• Tap (Press for < 1 second): Play/Pause
• Tap (Press for < 1 second): Answer incoming call
• Tap (Press for < 1 second): End a call
• Double-Tap:
• Hold:
•
+ / -
• Tap (Press for < 1 second): Track up/down
• Hold
• In standby mode: double tap to enable voice dial
•
Voice prompt
Voice prompt
Voice prompt
Voice prompt
Voice prompt
Voice prompt
Voice prompt
Voice prompt
Voice prompt
LED
LED
LED
BT Connection and Functions
Reject incoming calls
Shut down / Go into BT-pairing mode
Change volume (up/down)
Signals
„Power On" Device is powered on
„Power Off" Device is powered off
„Pairing" Device is in BT pairing mode
„Pairing complete" After successful BT pairing
„Connected" After successfully established connection
„Pairing not complete" When pairing did not work after 10 minutes
„Incoming call"
„Disconnected"
„Battery is low"
falshes blue BT: Headphones are ready to use / a BT connection is
flashes slowly (red) Low battery
solid (red) Charglng,and the red LED will turn off if
no lights Off
being searched for
charging finished.
9