Technical Data; Installation - Domus MAGIC TUNE TW Installationshandbuch

INSTALLATION MANUAL

TECHNICAL DATA:

Power supply: 24Vdc
Max power: 60Watt
Remote control range 15 meters.
Battery type used: CR2032 (3V) lithium.
WARNINGS
Safety is guaranteed is these instructions are followed and
therefore they must be kept. Installation may require
qualified personnel to be involved. Before proceeding with
installation of the device ensure that the environmental
conditions are in compliance with and suitable for the
product characteristics. Before any operation on the device
remove mains power.

INSTALLATION:

- Fix the support bracket (8) (Fig. 1) using the supplied screws
(9), or the double-sided adhesive (7).
- Insert the battery in the remote control (10) as shown in
figure 2.
PROGRAMMING THE RECEIVER IN SLAVE MODE (a
transmitter with a receiver, fig.5):
- Connect the receiver to the converter (not supplied), as
shown in fig.5.
- Connect the power plug to the power supply, the blue LED
(2) flashes.
- Briefly press the button (2) of the receiver.
- The blue LED (2) will remain lit for 60 sec. by which the
EN
Weitere Infos unter: http://www.lignoshop.de
programming operation must be completed, holding down
the power button (3) of the transmitter (1) for more than 5
sec. Turning off the blue LED (2) confirms the correct
programming of the system.
PROGRAMMING THE RECEIVER IN MASTER MODE (a
transmitter with multiple receivers, fig.4):
It is possible to control multiple receivers with a single
transmitter, in order to do this you must configure one (and
only one) receiver as "MASTER".
- Connect the receiver to the converter (not supplied), as
shown in fig.5.
- Connect the power plug to the power supply, the blue LED
(2) flashes.
- Hold down the button (2) of the receiver for more than 5
seconds, until the blue LED (2) flashes.
- Briefly press the button (3) of the transmitter (1).
- To verify the correct programming, run an on-off test.
NB: When a receiver is programmed as "MASTER", you
cannot reprogram it as "SLAVE".
OPERATION (Fig. 3):
- Key 3 = ON/OFF
- Key 4 = Increase the brightness
- Key 5 = Decrease the brightness
- Switch 6 = Light colour temperature adjustment