Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
■
Do not place any containers fi lled with liquid, for example vas-
es, directly next to the article.
■
Do not make any changes to the article and do not attempt to
repair it. In the event of any damage, please contact our cus-
tomer service department. The individual LEDs cannot be re-
placed.
Items Supplied
•
LED fi re place
•
Remote control, 3 V DC (1 x button cell, CR2025 type), already
inserted (The protective strip must be removed.)
•
Instructions
Inserting / Changing Batteries
Insert three 1.5 V batteries, C, Baby type into the battery
compartment on the back side of the article before you fi rst
use it. These are not supplied with the article.
Before inserting the batteries, check whether the contacts are
clean and clean them if necessary.
1. Open the battery compartment: Grip and press down the lock-
ing lug on the battery compartment cover. Lift up the cover at
the same time.
2. Insert three 1.5 V batteries of the C, Baby type into the battery
compartment. Ensure the correct polarity (+ / –).
3. Reattach the battery compartment cover and press it shut.
When you do this, make sure that the locking lugs sit in the
recesses which are provided for them. You must hear and feel
it engage.
Replace the batteries when the power of the article starts to wane.
PLEASE NOTE! Always replace all batteries together. Do not use
batteries of different types or brands, or batteries with different
capacities.
Changing the battery of the remote control
1. The battery compartment is located
pull
2. Take the used battery out and insert
press
3. Push the battery compartment back into the remote control to
the limit stop.
Putting Into Operation
1. Checking the items – Check the items supplied for complete-
ness (see the "Items Supplied" section) and possible transport
damage. If you fi nd any damage to the components, do not use
them (!), but contact our customer service department.
2. Attach or set up – Attach the article at a suitable height on a
wall using suitable fastening materials.
It is essential to follow the safety instructions for assembly
(see "Safety instructions" ).
The article can also be set up on a fl at, dry surface.
3. Insert batteries – Insert batteries into the article (see the "In-
serting / Changing the Battery" section).
4. Switch on / off – To switch on the article, press the On / Off
switch on the side of the article to position I.
To switch the article off again, press the On / Off switch to posi-
tion 0.
5. Stand-by-mode – To switch the article to stand-by mode,
press the OFF button on the remote
To switch the article on again, press the ON button on the re-
mote control.
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany •
*) Calls to German landlines are subject to charges. The cost varies depending on the service provider.
Article number: 03422
on the narrow side of the remote
control. Pull it out as shown.
a 3 V battery of the CR2025 type.
The positive pole must be facing up-
wards.
control.
Customer Service / Importer:
6. Timer –T o switch on the timer (24h mode), press the 4H but-
ton on the remote control. The article switches off automati-
cally after 4 hours and then back on again after another 20
hours. It can be switched back on again at any time by either
pressing the On / Off switch twice (position 0 → position I) or
pressing the ON button on the remote control.
All the buttons on the remote control only work if the On / Off
switch of the article has previously been set to the I (On)
position.
Cleaning and Storage
NOTE!
■
Under no circumstances should you use any corrosive or abra-
sive cleaning agents, rough sponges or knives to clean the
article. These could damage the surfaces.
1. Take the batteries out of the article (see the "Inserting / Chang-
ing the Battery" section).
2. Clean the article with a soft cloth and a little mild detergent if
necessary.
3. Thoroughly dry the article before it is stored away.
4. Store the article in a dry place that is protected from sunlight
and is not accessible to children and animals.
Technical Data
Article number:
Model number:
Voltage:
– LED fi re place:
– RC:
Disposal
Dispose of the packaging material in an environmentally
friendly manner and take it to a recycling centre.
Dispose of the article in an environmentally friendly manner
at a recycling centre for used electrical and electronic
devices.It should not be disposed of in the regular domestic
waste.
Batteries should be removed prior to disposal of the article
and disposed of separately from the article at suitable col-
lection points.
All rights reserved.
03422
BL10086
4.5 V DC (3 x 1.5 V batteries, C, Baby type)
3 V DC (1 x button cell, CR2025 type)
✆
+49 38851 314650 *)
Z 03422 M DS V1 0718
Instructions
Werbung
