Rebel DOVE Bedienungsanleitung Seite 21

Charging:
1. Open the battery compartment at the bottom side of the drone. Unplug the battery cable from the drone
and retrieve the battery.
2. Connect the red connector of the battery cord to the plug in the included USB charging cable.
3. Insert the USB connector into the AC wall charger, then plug the AC wall charger into a power supply
socket per the rating specified on the included AC wall charger; OR plug the included USB charging
cable into PC USB port.
4. During charging, the red indicator will light up on the USB charging cable. Once the charging is
completed, the indicator will turn off.
5. After charging the battery, disconnect it from the USB charger cord.
6. Place the battery back to its original place, connect the red plug of the battery to the socket on the
drone. Close the battery compartment cover.
Note:
• Use only included accessories to charge this product.
• Never leave battery unattended while charging.
Estimated charging time: around 90 minutes
Please note, the above charging time is only an estimated value and may vary depending on models due
to various miscellaneous reasons.
1. Speed select / Compass mode / Autotrim
Speed Select
Press the Speed button to toggle through speed options.
• Slow speed, one beep.
• Middle speed, two beeps.
• High speed, three beeps.
Headless (compass) mode
• Press and hold Speed button for about 3 seconds till device starts to beep to enter Compass mode.
• Press and hold Speed button for about 3 seconds till device stops to beep to quit Compass mode.
2. Throttle / left stick
3. Trim slider B
Owner's manual
the Drone
controller
EN
21